Original link: https://yf-ch.com/archives/1969.html
In the past few days, I have nothing to do. The Phicom k2p router, which was used for wool, has been eating ashes for many years. I thought that the WiFi signal in the study was not very good. I swiped the machine and put it in the second bedroom. The gigabit network at home is unsatisfactory, but it is enough.
leave the brush method
Official firmware version:
K2P: V22.214.171.124 V126.96.36.199
(The V188.8.131.52 version needs to be upgraded to the above version)
(versions below V184.108.40.206 need to be upgraded to V220.127.116.11 first)
K2p: Official version V18.104.22.168
Green and compact, no need for networking, no firewall or administrator rights to open the routing management page, both wired and wireless connections can file MD5 multi-authentication, absolutely safe and compatible with many versions…
Download the helper tool and unzip all files to any directory.
Double-click to run the flash machine.bat and enter the IP and password of the router as prompted. If it is the default, press Enter directly.
(For new or factory reset routes that have not been set, press Enter and follow the prompts to configure the route)
Waiting for the router to restart, the browser will open the router page in about 1 minute. If the automatic login is successful or the manual upgrade page changes, it means that the breed is successful.
(Admin password: tbvv.net)
Then enter: Advanced Settings -> System Settings -> Manual Upgrade -> Download Backup EEPROM (it is a compressed package).
ASUS padavan (wilderness without lights)
Advanced Settings—> System Settings—> Manual Upgrade—> Browse—> Select the firmware you downloaded—> Click to upgrade.
(The inaccuracy of the web page flashing progress bar can be ignored. The process of firmware writing, restarting, and initializing the first boot actually takes 3-5 minutes. Don’t worry, if the firmware is not compatible, you need to manually re-brush the breed)
Manually enter the breed brush
Unplug the network cable of the routing WAN port to avoid IP conflicts, connect the computer network cable to the routing LAN port, and set the computer network card to automatically obtain IP
Power off the router for 3 seconds—> press and hold the reset button and don’t let go—> insert the power supply—> release the reset button after waiting for 5 seconds—> enter 192.168.1.1 in the browser—> firmware update—> select the firmware to flash.
(If the webpage is wrong, it means that the WAN port IP conflict or the browser cache has not been cleared)
(Flash memory layout: most of the K2 firmware is 0x50000, the official firmware after V22.5.XX.XX chooses 0xA0000, the firmware cannot be unified, if it does not start, change to another layout and re-flash)
ASUS padavan (hiboy): https://www.right.com.cn/forum/thread-161324-1-1.html
ASUS padavan (wild without lights): https://www.right.com.cn/forum/thread-187654-1-1.html
PHICOMM K2 official firmware customized version: https://www.right.com.cn/forum/thread-208753-1-1.html
Tomato Phoenix: https://www.right.com.cn/forum/thread-216905-1-1.html
PandoraBox Pandora: https://pangubox.com
GOCLOUD Gao Ke: http://www.gocloud.cn/bbs/thread-543-1-1.html (SSH)
Tomato DualWAN (Broadband Treasure): http://bbs.91kdb.com
This article is reproduced from: https://yf-ch.com/archives/1969.html
This site is for inclusion only, and the copyright belongs to the original author.