The server uses systemd to automatically start wireguard

/ Frytea | 宋天轮

Original link: https://blog.frytea.com/archives/761/

75

  1. Generate a valid and working WireGuard configuration file /etc/wireguard/wg0.conf. Our setup guide offers details. Note: You may have to replace the Endpoint hostname with the WireGuard server IP address in the WireGuard configuration file. DNS may or may not be applied when systemd brings the wg0 interface up.

  2. Add the WireGuard service to systemd

     sudo systemctl enable [email protected] sudo systemctl daemon-reload

  3. Start the new service immediately:

     sudo systemctl start wg-quick@wg0
  4. Reboot your computer system to verify the automatic connection on startup works as expected.

  5. Check the service status:

     systemctl status wg-quick@wg0

  6. To remove the service and clean up the system:

     sudo systemctl stop wg-quick@wg0 sudo systemctl disable [email protected] sudo rm -i /etc/systemd/system/wg-quick@wg0* sudo systemctl daemon-reload sudo systemctl reset-failed

References

This article is transferred from: https://blog.frytea.com/archives/761/
This site is only for collection, and the copyright belongs to the original author.